In addition to a drop in temperatures, Brits can expect more showery weather as we progress into the colder months of the year. More rainfall is expected across the nation this week, with the weather agency even issuing flood warnings for certain areas.
Aside from flooding, rainy weather can cause many other disruptions. For drivers, rainfall and cold weather result in one particularly annoying issue: foggy windscreens. This is caused when the temperature inside a vehicle is higher than the temperature of the glass.
The warm and humid air then condenses on the cooler inner surface, making it difficult to see clearly. However, there is a simple method to solve this issue with just two buttons inside your car, according to an expert at FixMyCar.
Matt Wrankmore, head of garage network at FixMyCar, told Sun Motors: "Before parking, blast cool air briefly to reduce humidity in the cabin.
"In the morning, use warm air and switch on the air conditioning, which acts as a dehumidifier and clears the glass without smearing."
The expert also revealed a quick and cost-effective method to prevent door seals from freezing up overnight.
According to Mr Wrankmore, all you need to do is apply a smear of Vaseline (petroleum jelly) to the rubber door seals of your car to prevent them from sticking and freezing in cold, damp conditions.
He explained: "A light smear of Vaseline on rubber door seals helps prevent them from freezing shut, although it should not be used on wiper blades.
"Keeping locks dry and covered where possible also reduces the chance of freezing."
This technique forms a moisture-resistant barrier that doesn't freeze, helping the rubber remain supple and preventing water ingress from bonding the seal to the door frame. It is also best used on the rubber seals around car doors and the boot, where freezing and sticking are most likely to occur.
You should, however, avoid using Vaseline on wiper blades as it can smear the windscreen and even degrade certain rubber compounds over time.
To carry out the method properly, first clean the seals with a damp cloth to remove dirt, grit and any residues that could trap moisture.
Dry the seals thoroughly, as applying Vaseline to damp rubber will reduce its effectiveness.
Then, apply a very thin layer of Vaseline using a soft cloth or your fingertip along the length of the seal to create a light sheen, rather than a visible layer.
